MILK COOLING TANK

  • Space - saving, ergonomic design, easy to clean.

  • Available in 1 & 2 milking

  • The milk cooling tank is constructed of stainless steel material conforming to AISI-304 class (18/10), hermetically sealed finished & well polished.

  • One piece top cover made of 1.5mm thick stainless steel sheet mounted on pneumatic spring, allowing easy opening & closing.

  • The milk cooling tank consists of milk vessel made of 1.5mm tick stainless steel sheet mounted on pneumatic spring, allowing easy opening & closing.

  • Compact polyurethane foam insulation 38mm at top & 100 mm at bottom thickness ensures perfect insulation (sandwich construction).

  • Stainless Steel Evaporator 0.9 mm tick "Laser Welded" with the milk vessel of 1.5mm thick stainless steel sheet.

  • Efficient agitator, 30-36 rpm speed with level control switch ensures even & gentle mixing of milk & prevent freezing.

  • Milk cooling time from 35 to 4 deg C will be within 3 hrs & 30 minutes.

  • Detachable butterfly valve DN-50, sms thread

  • The control panel (analogue type) ensures 100% automatic operation with auto/manual agitation & milk temperature control system. The panel conform IP-55 class with over/under voltage & phase failure relay.

Cooling Machine

  • The cooling machine is designed / developed to operate at local ambient temperature of 50 deg C.

  • Three Phase, 380-400v,50hz, hermetic compressor, 5 HP capacity, USA/France make.

  • All contactors and overload relays are of "TELEMECHANIQUE-FRANCE"

  • Low & High pressure switch with auto reset is of "DANFOSS-DENMARK".

  • Air-cooled condenser compatible with local ambient conditions.

  • By-pass solenoid value "DANFOSS" WITH Evr/timer arrangement for easy start up of compressor.

  • Cooling Machine mounted on powder coated ms foundation & attached with the cooling unit with proper cover protection.

 
  1  |  2  |  3  |  4